Pull Out Testing & Push Pull Stress Load Testing

Push Pull Testing by Abbot Technical Services Limited as an approved on-site Anchor Fixings Tester for construction industry. Pull-out/proof load testing of structural fixings for the construction industry. Trustworthy load testing results from a team of test technicians and anchor fixing specialists. We are members of the construction fixings association as an approved tester of Scaffold Ties, Post-Installed Rebar fixings and Remedial Wall-Ties to 320kN Push Pull mechanical stress load levels.

We can conduct a range of stress push pull tests for most industry fixings, anchorages and materials. Our services may be conducted against general purpose fixings of sizes M6, M8, M10, M12 or M16 anchorages. We can test and measure accurately to small load levels such as 20 or 25kN or with larger load levels up to 320kN.

We ensure the load capacity and therefore the safety of fixings used in the construction industry. Our onsite testing results are charted and then entered upon an in-house and custom developed computer system. Our post visit on-site reports shows clear and identifiable conformance of fixings to on-site test load levels. Each and every fixing component is clearly identified together with the load stresses applied. Our services are second to none with evidence of our testing and compliance to standards being provided via the PDF client reports.

Abbot Fixings Systems Ltd have been conducting on-site push-pull fixings tests for 20 years and has built up a highly experienced team. We can also use our experience of installing construction fixings and can overcome most on-site mechanical problems due to our fabrication methods and our experience as installers.

As an engineering manager of a construction site you can rest assured that our services have been diligently provided to accepted industry standards BS 5080 Part 1.